How do i hook up an amp in a car
Step 1: Parts
For multiple amplifiers you will need to add up the maximum current draw of each amplifier. This is why the amplifier has to be placed in a well-ventilated area of the car.
You just installed a car audio amplifier. If it does, then turn your car off and make sure the amp turns off as well so it sc dating during separation drain your battery. Disconnect the negative battery terminal.
Take that fuse out, wrap the remote wire around it, and connect it back where it was. Your amp will always be on when your car is on, but it shouldn't make noise, so its OK. For the need to replace a stock radio, you do not have to do it all the time.
Turn up the deck's volume until you hear distortion, and set it just below that level.
Introduction: Installing Subwoofers in a Car
Better yet, go out and by a new stereo that has Hook up boss plow. Screw the speaker into the box, using the holes on the outside rim of the speaker. Connect the power cable from the battery into the spot on the amp that has one of the following markings do not connect it to the speaker positive: Power from the fuse box often is "unclean" and you may hear your engine noise amplified through your speakers.
But honestly, if you have to wear earplugs to listen the distortion level is probably not a factor: Can any of you help me.
Continue this process until you have all of the components in the chain at their maximum undistorted level. Not Helpful 0 Helpful 1. A lot of Stereos including mine, doesn't have an internal amplifier and i need a 5 channel amp for all my speakers and subwoofers.
Determine what side of the vehicle the battery is on. When you hear it, stop and back off slightly until you no longer hear it.
You want to choose a speaker and amp that put out the most power, without blowing each other. Installing an amp can be done without the help of a professional, allowing you to get great sound without an installation fee.
What power supply wire gauge should I use? This could induce noise into your system although it is less likely than picking up noise through the RCA cables.
This wire tells the amp that the stereo has turned on, and that the amp should too. The welds in some such vehicles involved in crashes were found to have spilt along hairline cracks, introduced by the use of subwoofers, or by panels splitting at rust points.